WM Series Coil Head (5pk)


Wismec

$18.50 
Availability: 4 in stock

Compatibility

  • Wismec Gnome
  • Wismec Gnome Evo
  • Wismec GEN3 + Gnome Kit
  • Wismec Sinuous Ravage 230 Kit

The Technical Stuff

    • WM-M
      • Mesh Wire Coil Head
      • Wire Material: Kanthal (KA1)
      • Resistance: 0.15ohm
      • Wattage Range
        • Maximum: 40~100W
        • Best: 65~70W
      • Operating Modes:
        • Bypass
        • Variable Wattage
    • WM01
      • Single Coil Head
      • Wire Material: Kanthal (KA1)
      • Resistance: 0.4ohm
      • Wattage Range
        • Maximum: 40~80W
        • Best: 55~65W
      • Operating Modes:
        • Bypass
        • Variable Wattage
    • WM02
      • Dual Coil Head
      • Wire Material: Kanthal (KA1)
      • Resistance: 0.15ohm
      • Wattage Range
        • Maximum: 30~70W
        • Best: 45~60W
      • Operating Modes:
        • Bypass
        • Variable Wattage
    • WM03
      • Triple Coil Head
      • Wire Material: Kanthal (KA1)
      • Resistance: 0.2ohm
      • Wattage Range
        • Maximum: 40~130W
        • Best: 70~90W
      • Operating Modes:
        • Bypass
        • Variable Wattage
    • WM RBA
      • Designed for Dual Coil Wire Builds
      What's in the Box?
      • 5 x WM Series Coil Head (except RBA)
      • 1 x WM Series RBA Head (RBA Only)

      Warning

         

        • Always 'prime' coil with e-liquid prior to use. 5 minute 'prime & sit' time recommended. Failure to do so may lead to the cotton being burnt within the coil head, this will lead to an unpleasant 'burnt' taste making the coil head unfit for use.
        • Thoroughly dismantle, clean and inspect all tank components for wear, faults or replacement of rubber O-rings and or seals. Failure to do so may cause the newly installed coil head to not work correctly and may even damage preventing further use.
        • Do not attempt to clean used coil heads with water, this will lead to the coil wire rusting and should be strongly avoided. However, if the coil head needs to be 'freshened' due to a change in e-liquid flavour then we recommend the use of isopropyl Cleaning Alcohol. Simply submerge coil head in a small cap full of isopropyl and lightly agitate and even use an old tooth brush to gentle clean away any contaminants. CAUTION: Allow the coil head to FULLY DRY in a shaded dry area before use.

            Our Brands